I have checked that the grub screw under the pedal is sufficiently tight, so that is ruled out. Therefore it seems to be the Hall Effect sensor that has failed – again (I replaced the original a few years ago). Assuming my analysis is correct, where can I obtain a replacement? Fanatec seems to have erased the V1 set from its website.
There is one thing, though, that suggests that the problem may be elsewhere: in Fanatec's site, there is a Q&A on throttle problems, with this:
If the problem was not solved please take off the main PCBA of your CSP (V2) which is located on the bottom of the pedals. Now switch the sensor cable from the accelerator to the clutch and check again.
I tried that and the throttle worked properly in Game Controllers.
What should I do next?
Edited by Dronzo, Aug 31 2020 - 07:22 AM.